Make sure you crank arms are installed 180° from each other.
The left pedal must go on the left. It is reverse thread, to install it, you must properly align it and then rotate it by hand counter clockwise to begin threading it in. Then tighten with a wrench no wider than the flat.
The right pedal must go on the right. It has a standard thread. Rotate by hand clockwise to begin. Then tighten with a wrench no wider than the flat.
Make sure your fork is on correctly and not backwards (brake caliper and rotor goes on the left side of the bike).
Route your brake cable inside the fork to keep it safe when moving, storing, and transporting your bike, you may need to adjust the angle of your brake levers. Click here for more detail: Routing brake line
Adjust your brake levers forward and down so you can easily access them while maintaining good grip and control on handle bars.
Before installing your fork inspect wire and cable routing, please compare yours to the video. The wires should not cross over.
Handlebars - You may need to flip the handlebars before installing (left to right, right to left, front to back, back to front) so the wires are properly routed and the handlebars properly installed. The display goes on the left, the shifter goes on the right.
Do not squeeze brake levers before brakes are installed.
Before you install the front wheel, remove the plastic spacer from the front brake caliper, it is in between the brake pads. This is can be used anytime you remove the front wheel, so save it.
Do not touch the brake rotors with your fingers. The oil can contaminate them and cause them to be noisy when used.
The front brake caliper should be installed in this position for the spacers and bolts.
The longer bolt and thicker part of the spacer goes at the top.
If you are not familiar with installing this or not familiar with bicycle part names, it may be best to have it assembled by a bike shop. As with many bike components, proper installation is important to avoid damage to the bike and to avoid injury while riding the bike.
If you are unsure, please stop, take some pictures and contact us.
Carefully install fork fully, make sure it is seated well with the bottom of the head tube and the lower bearing that is inside the bottom of the head tube. Only the crown race should be on the fork steerer tube at this time. The lower bearings are already in the lower cup at the bottom of the head tube. Along with a dust cover.
Once the fork is installed through the head tube, place the compression ring on the top of the fork steerer tube.
Slide it down, the lip of the compression ring will insert just inside of the bearing when the fork steerer tube is properly centered. This make take some adjustment to get it to sit just right.
Next place the cone spacer or conical spacer on. Make sure the plastic/ring or dust cover is also installed with this. It should fit right on this spacer.
Add remaining spacers on steerer tube.
Put stem on on steerer tube (but do not tighten bolts yet!). Are you handle bars on correct? Are the wires and cables routed properly?
Insert top cap and bolt, carefully tighten the top cap bolt as shown in the video until you begin to feel resistance rotating the fork, at that point you may even back it off a few degrees. Does it the fork turn smoothly? Does the fork shift up and down relative to the head tube? It should not shift up and down relative to the head tube.
Now you can tighten bolts on stem where it connects to steerer tube. Please be careful and slowly tighten in a criss cross pattern. Do not over tighten or you may strip the stem.
Check to make sure, there is no "play" in the fork. If the fork is properly seated and tightened, the fork should not shift up and down relative to the head tube of the frame.