This written guide will walk you through assembling and attaching the Connect+ Rear Rack

You can also refer to the YouTube assembly video below: 




Installing the rear rack on your bike requires assembling the main platform, attaching it to the bike frame, and securing the mounting rods. Follow these steps carefully to ensure a secure and stable installation.


Materials Needed

  • Rack Platform

  • Two supporting rods, black rods

  • 4 x Black Bolts, Washers, and Hex Nuts

  • 2 x 5mm Machine Screws and Hext Nuts

  • 2 x “O” supporting screw

  • 2 x “U” Bracket 

  • Allen Key Set

Step-by-Step Instructions

Step 1: Unpack & Gather Components

  1. Gather the main components on a clean flat surface or working area. 

  2. Begin by laying out the main rack frame. 

Step 2: Assembling the Rack

  1. Position the brackets so the vertical support is at the front and the diagonal support extends towards the back.

  2. Mount the support bracket on the outside of the platform.

  3. Loosely assemble the bolts and do not fully tighten until fully constructed.

Step 3: Attach the Rack to the Bike Frame

  1. Align the rack with the designated mounting points on the frame. 

  2. Use the short machine screws to attach the rack to the bike. 

  3. Screw both sides in loosely and leave some room for adjustment and alignment. 

Step 4: Assemble and Attach the Front Mounting Rods

  1. Place the thicker machine screw (5mm head) on top of the flat part of the half-circle bracket.

  2. Insert the large half-circle bracket with the unique screw that has a large hole.

  3. Lightly secure the nut on the other side.

  4. Slide the rod through the large hole in the bracket; this will allow for sturdy rack attachment. 

Step 5: Attach the Front Rods to the Bike

  1. Position the rods under the seat, the rods should curve inwards towards the center of the bike frame. 

  2. Secure the assembly, remove and replace the screw on the flat side of the half-circle bracket, locking the rod into place. 

  3. Repeat the process on the opposite side. 

Step 6: Final Tightening and Adjustments 

  1. Tighten the rear end of the rack first and gradually move to the front, make sure to alternate tightening to maintain balance and center. 

  2. Secure lower mounting screws and fully tighten the screws attaching the brackets to the bike frame. 

  3. Secure the platform tightly to finalize the rack assembly. 

Final Steps & Review

  • Ensure all bolts are tightened securely.

  • Test the rack attachment by pulling gently side to side to confirm it is locked in place.

For any questions or additional assistance, please contact customer support.