This written guide will walk you through assembling and attaching the Connect+ Small Basket.

Materials Needed

  • Connect+ Small Basket (2 end pieces)

  • 4 Basket Connector Rods

  • 4 Phillips Screw

  • 8 Small Screws 

  • Connect+ latch attachment

  • Basket plate

  • Basket lining and cargo net

  • Phillips Screwdriver

  • End Piece Connector for Rift (included only for Rift models) 

  • Ride1Up Hex Key Set (provided with bike)

Step-by-Step Instructions

Step 1: Assemble the Basket Frame

  1. Insert the four black rods into one side of the basket.

  2. Place the other half of the basket on top, ensuring it is fully attached.

Step 2: Secure the Basket Frame

  1. Twist the four rods to align the holes properly before inserting the bolts.

  2. Take two small screws and screw them into the rod inserts on the inside of the basket using a hex key.

  3. Take remaining screws and thread them into the remaining rod inserts at the back of the fully secure basket frame. 

  4. Ensure that the screws are flush with the frame of the basket, making sure they are not overtightened. 

Step 3: Install the Connect+ Attachment

  1. Place the Connect+ latch attachment inside the basket to rest on top of the 4 tabs of the basket. The orientation of the Connect+ latch is up to the user’s preference and will determine the positioning of the small basket on the bike. 

  2. Place the black basket plate on top of the Connect+ attachment, inside the constructed basket, and align the 4 holes.

  3. Take the four long screws and insert them through the tab inserts and thread screws to ensure all three pieces (basket frame, Connect+ Latch and basket plate) are connected. 

Note for Rift Models: Prior to installation, remove the Connect+ end connector piece located towards the back of the Connect+ Latch. Use a Phillips screwdriver to replace with the Rift-specific end connector included with your basket to ensure proper fit and alignment. 

Step 4: Attach the Basket Lining and Cargo Net

  1. Using the velcro flaps, secure the basket lining along the edge of the basket.

  2. Attach the cargo net over the top for added security.

Step 5: Attach the Basket to Your Bike

  1. Use the Connect+ system to attach the basket securely.

  2. Push down until you hear a click, confirming it is locked in place.

Step 6: Removing the Basket

  1. To remove the basket, pull the Connect+ latch located under the basket.

  2. Lift the basket off the rack.

Final Steps & Review

  • Ensure all bolts are tightened securely.

  • Test the basket attachment by pulling gently to confirm it is locked in place.

For any questions or additional assistance, please contact customer support.