Materials Needed

  • Ride1Up Hex Keys 

  • Pre-Built Revv Storage Cage

  • Flat Screws 

Step 1: Remove Storage Cage from the Box

  1. Remove the storage case and lay it on a flat surface. 

  2. Remove the four preinstalled hex screws on top of the controller box.

  3. Save the existing hardware for installation or use provided hardware. 

Step 2: Secure Storage Cage

  1. Align the storage case and ensure pre-drilled holes are lined up with the Controller box. 

  2. Using supplied flat screws, thread into the controller box, tighten until flush with the storage case. 

Step 3: Setting a unique code for the Center Storage Cage combination lock

  1. Note: Pre-set code is 000. 

  2. Push the small silver code setting pin on the side of the circular dial in with a small instrument or screwdriver.

  3. Set your desired code

  4. Remove the screwdriver, allowing the setting pin to return to place.

Final Steps & Important Notes

  • Ensure the cage is secure and tight by gently moving the cage. 

  • Periodically check the flat screws to ensure they are secure to the controller box.  

For any questions or additional assistance, please contact customer support.